You are not logged in.
Pages: 1
Hi there,
I have a GLPI 0.80.7 installed and I'm trying to use Shell Commands plugin v. 1.4.0.
I have this kind of problem: I want a normal user to ping a networked Computer but, when I enable the reading permissions on normal profile I can't see any command on Shell Command tab in the computer entity.
The same if I enable writing rights on the profile.
How can I add any shell command to normal profile?
With super-admin privileges anything works well.
Thanks in advance for the support.
Last edited by carlo.beninsegni (2012-05-15 11:31:06)
Offline
Had the same problem. But I figured it out after painstaking debugging...
In the target profile, on the Administration/Setup tab, you have to have "External Links" set to "read", else none of the commands you define in the Shell Commands plugin will show up...
Good luck!
Offline
Pages: 1