Forum GLPI-Project

Sebretian

Member

From: Ontario, Canada

Registered: 2008-03-01

Posts: 3

Website

All data not coming across from OCS

I'm very new to OCS and GLPI.  The software is fabulous and extremely helpful in our hospital environment.  Thanks alot for doing it.

When I initially set up GLPI, check the button to use OCS, I am only getting computer name and no other data.  Have deleted the config file and reinstalled GLPI a couple of times, always with the same result.  I may have screwed something  up when I did the very first install.  It wasn't importing software, so as per instructions, in OCS, I changed the dictionary for software to UNCHANGED.  After that I didn't get any data in GLPI  except computer name.  Any suggestions?
David

remi

GLPI-DEV

From: Champagne

Registered: 2007-04-28

Posts: 7,127

Website

Re: All data not coming across from OCS

Yes, all the OCS data are not imported to GLPI

See : https://dev.indepnet.net/glpi/wiki/MissingDatas

But software are imported with a good configuration.

Try to uncheck to "OCS Software dictionary" in GLPI configuration.

++

---

Dév. Fedora 29 - PHP 5.6/7.0/7.1/7.2/7.3/7.4 - MariaDB 10.3 - GLPI master
Certifié ITILv3 - RPM pour Fedora, RHEL et CentOS sur https://blog.remirepo.net/

Sebretian

Member

From: Ontario, Canada

Registered: 2008-03-01

Posts: 3

Website

Re: All data not coming across from OCS

No I mean I'm not getting any other data.  I get computer name and last update and that's it.

Just tried it again after adding 20 servers to OCS Inventory.  Set GLPI up again after deleting the config_db.php file.  Still only get computer name and last update.  Now I'm only getting 20 of the 60 servers.  When I first set up GLPI and I "import new computers", it lists all 60 servers but only 20 make it through.  When I list "computers" under "Inventory", it says I only have 20 computers and doesn't show anything other than computer name and last update.

remi

GLPI-DEV

From: Champagne

Registered: 2007-04-28

Posts: 7,127

Website

Re: All data not coming across from OCS

Deleting the config_db.php is not enough, you must also drop the GLPI database.

Check your OCS mode configuration.

You have to set "Yes" to all the data you want to import.

++

---

Dév. Fedora 29 - PHP 5.6/7.0/7.1/7.2/7.3/7.4 - MariaDB 10.3 - GLPI master
Certifié ITILv3 - RPM pour Fedora, RHEL et CentOS sur https://blog.remirepo.net/

Sebretian

Member

From: Ontario, Canada

Registered: 2008-03-01

Posts: 3

Website

Re: All data not coming across from OCS

Merci beaucoup Remi!..

The OCS Mode configuration was my problem.  Actually didn't know about it. Selected what I wanted imported and unchecked the dictionary.  Works fine now and all information has come across.
Fantastique :-)