Forum GLPI-Project

Destroit

Member

Registered: 2023-08-30

Posts: 5

How to deploy SNMP by Fusion Inventory

Good morning, Hello guys. I am new to GLPI and would like to know how to use the GLPIN INVENTORY Plugin:

- To collect information from switches and routers using SNMP;
Because I was able to perform the inventing of computers and software only the manageable switches did not find.

I couldn't find much information on how to use this features. Could you indicate any material?

InvisibleJim

Member

Registered: 2023-11-26

Posts: 14

Re: How to deploy SNMP by Fusion Inventory

I don't have access to my GLPI server right now or the link to the instructions I used but here are the approximate steps I took to get this working:

Set up credentials for SNMP community on the switches
Enable Netdiscovery and NetInventory modules on one or more agents
Configure the IP ranges that you want to inventory int the GLPI inventory plugin
Configure Netdiscovery jobs for those IP ranges and run Netdiscovery
Configure NetInventory jobs and add the devices you wish to monitor that were discovered in the Netdiscovery job (IIRC you have to select each device manually. There may be a better way but I haven't found it yet)

I hope that helps. If I can find the link to the article I referred to, I will add it.