Forum GLPI-Project

Ger_p

Member

Registered: 2023-04-06

Posts: 2

Glpi inventory works only if i press "force execution"

Hi all,

i set up glpi to inventory my network using glpi inventory and crontab.
everything works fine if i press "force execution" in specific job.
In fact, if i press that button i can see all tasks in "prepared" status and after a few minutes crontab start glpi-agent.
But if i set timeslot for prepared task doesn't work, no task will be in "prepared" status and i can't inventory nothing.

Anyone can help me?

Note: i have GLPI 10.0.6 and glpi-agent 1.4

Thanks in Advance,
Ger

Last edited by Ger_p (2023-04-20 11:00:49)

Chico008

Member

Registered: 2022-12-14

Posts: 429

Re: Glpi inventory works only if i press "force execution"

when a task is set to prepared state
you have to wait for your agent to contact the server (when it will make an inventory for example)

then, the agent will see from the server a task is assigned to it, and it will run
you don't have to force a sync on the agent, juste wait for it to contact the server

Ger_p

Member

Registered: 2023-04-06

Posts: 2

Re: Glpi inventory works only if i press "force execution"

Hi Chico008,

thanks for your reply.
The problem is before task set in prepared status.
If I set a timeslot for my job, this job won't set to "prepared status" even if time is in timeslot.
The only way to have task in prepared state is "force execution" that job.