Forum GLPI-Project

Mmmax

Member

Registered: 2022-07-14

Posts: 3

Tasks management - Agent for Network and VMWare discovery

Hi,

I have an issue with the Discovery on GLPI V10

I followed the Guide to configure it and I try to find what's wrong

1 - I set The credentials for SNMP v1 and v2 (Public community)

2 - I set an IP Range with IP of all our equipment / Hyper-Vs / ESXs. then associated the SNMP credentials

3 -I set an agent port - 62354 (automatically selected)

4 - I configured a task , Network discovery, Target : my IP scope and Actor my GLPI Agent

5 - In Agents management, I set the same port - 62354 and added all the modules to be sure

6 - To finish on task management I clicked Force Start

On task status I have my tasks stuck in "Prepared" "Not done yet"

Can you see any configuration issue ?

Thank you

Regards
Max

Mmmax

Member

Registered: 2022-07-14

Posts: 3

Re: Tasks management - Agent for Network and VMWare discovery

Hi

I also have absolutely 0 logs..

No glpi folder or file into /var/log
according to the documentation i also tried to create the folder but nothing is populated in

Max

gbougard

Moderator

From: Montpellier, France

Registered: 2021-07-21

Posts: 537

Website

Re: Tasks management - Agent for Network and VMWare discovery

Hi Mmmax,

netdiscovery & netinventory tasks can only handle network devices and printers. For ESX inventory, you can use the esx task. For Hyper-V, you should install GLPI-Agent on the host.

---

GLPI-Agent developer from Teclib' and GLPI-Network team
Previously FusionInventory-Agent maintainer