Forum GLPI-Project

spheron

Member

Registered: 2007-08-02

Posts: 32

Deleting Netpoint in Switch Config

Hello @all,

using here GLPI 0.68.3-2 and i having a small problem with the netpoints.

To assign a computer to a switch i used the config-cialog of the switch. If i assign a computer to a emtpy switch port the netpoint of the computer is set correct into the netpoint-field of the switch-port. Now i disconnect the computer from the switch and the netpoint config still exist in the switch config dialog. Now i assign another computer with a different netpoint to the same switch port and the old netpoint config was NOT overwritten... :-(

PC1: Netpoint 1-2
PC2: Netpoint 3-5

You can reproduce this in the config dialog of the switch with following steps:

Step 1:
Add PC1 to switch port 1

Result:
Netpoint      Computer
1-2                 PC1

Step 2:
Delete PC1 from switch port 1. Config after that:

Result:
Netpoint       Computer
1-2                (empty)

Expected Result:
Netpoint       Computer
(empty)         (empty)

Step 3:
Add PC2 to switch port 1.

Result:
Netpoint       Computer
1-2                 PC2

Expected Result:
Netpoint       Computer
3-5                 PC2

Is this a problem in 0.68.3-2??? I dont test the 0.7RC1 if there is the same behaviour...

Hope someone can help me. Many thanks...

Greets
Marco