Forum GLPI-Project

theburn

Member

Registered: 2014-04-03

Posts: 57

FusInv - Printers Graphs - change ?

Is it possible to change the graph type for printers ?

I've only get one with all datas merge in and this is totally horrible x_x

I've also tryed to desactivate some OID to doesn't check them but graphs are still putting those datas into it.

Here's a screenshot of the graph I got (not the same as those great ones before with thin lines)

ddurieux

Plugins Dev

From: Propières, France

Registered: 2005-06-17

Posts: 7,521

Re: FusInv - Printers Graphs - change ?

Try to click on 'stacked' on top

theburn

Member

Registered: 2014-04-03

Posts: 57

Re: FusInv - Printers Graphs - change ?

Had already tryed but I get totally wrong numbers (some prints had been counted for 4-5 times, depending it a black&white, one side, two sides,....) and only one column with all merged inside.