You are not logged in.
Pages: 1
Topic closed
I have some problems with this plugin.
I've added all computers and switches to glpi, then I've wrote switches port and connected computers and other switches to each other. Now I need Archire to show me all my network, like a map, but it let me only to choose one switch, it doesn't show me all devices in one map.
For example: I have switches A,B,C and computers a1, a2, a3; b1, b2; b3, c1, c2, c3. When I choose A, it shows me only one switch B (doesn't show computers on B), and computers a1, a2, a3. If I want to look b computers, I have to choose switch B.
What I may did wrong? Or maybe It doesn't support such maps?
Please, help me.
Offline
Hi,
Have you added to Display types of items, a1,a2, etc computer types?
Offline
Yes, all devices are enabled.
When I select for example switch A it shows me only computers on this switch and one another switch (B) connected to A, but doesnt shows computers on B. I have to select switch B to see computers on it.
Offline
So, are you using Network architecture by networking device if so, this is the expected behaviour, since its showing only devices attached to a single device (SWITCH A).
You should try Network architecture by location
Hope it helps
Cheers
Offline
can you post a screenshot of how the maps look?
Thanks,
Dan
Offline
So, are you using Network architecture by networking device if so, this is the expected behaviour, since its showing only devices attached to a single device (SWITCH A).
You should try Network architecture by location
Hope it helps
Cheers
Thank you very much! It helps!
Offline
can you post a screenshot of how the maps look?
Thank you for the response! All works!
Offline
Pages: 1
Topic closed