You are not logged in.
I am attempting to use the mreporting plugin with GLPI to get exports of our inventory. As a demonstration, I want to be able to export all machines within a certain timeframe that have the 'Inactive' status.
When I go to the section of 'Reports List' within 'More Reporting', the only export option I see is ODT. After opening said page, I check the 'Computers by status' box (need this to be more specific eventually but not important yet). I have tried 'With Data' and 'Without Data' (not knowing the difference).
I select a range of dates and hit the Export button, which results in the following response:
'Please, select a model in your preferences'
I searched through the site and online for how to actually select a model in preferences, but it doesn't seem clear at all how to do it. I would be very grateful if I could receive some help if this is a configuration issue on my end.
Offline
I have the same issue. I haven't found documentation regarding that. Tnx
Offline
Good afternoon,
You have seen 'Please, select a model in your preferences'
So, i'm explaining what i have done.
Clic on your initials on the up right corner of GLPI
go down to "My settings"
if you have More Reporting installed, you can see a "More reporting" tab to the right after "Main" and "Personalization"
Clic on More Reporting Tab
I saw the version 1.8.6 and a list with template.odt and a "Post" button
Deploying the list, i had no other choice that template.odt...
I click "Post"
Then i go back to the More reporting graphics, and i use the export function, it's works better !
Best regards
Offline