Forum GLPI-Project

carlo.beninsegni

Member

Registered: 2012-05-15

Posts: 1

Problem with Shell Commands plugin

Hi there,

I have a GLPI 0.80.7 installed and I'm trying to use Shell Commands plugin v. 1.4.0.
I have this kind of problem: I want a normal user to ping a networked Computer but, when I enable the reading permissions on normal profile I can't see any command on Shell Command tab in the computer entity.

The same if I enable writing rights on the profile.

How can I add any shell command to normal profile?

With super-admin privileges anything works well.

Thanks in advance for the support.

Last edited by carlo.beninsegni (2012-05-15 11:31:06)

bhuntsman

Member

Registered: 2012-07-20

Posts: 8

Re: Problem with Shell Commands plugin

Had the same problem.  But I figured it out after painstaking debugging...

In the target profile, on the Administration/Setup tab, you have to have "External Links" set to "read", else none of the commands you define in the Shell Commands plugin will show up...

Good luck!