You are not logged in.
Hallo from Germany,
I know that my questions mainly refer to FusionInventory Plugin, perhaps anybody can still help. I am open to alternatives for scanning the network, but with OCS Inventory for example it was not possible to import the software list to GLPI.
I am using GLPI 0.80.7 with FusionInventory Plugin 0.80 1.1.
After scanning the network I got 620 SNMP models... There are only recognized the chipsets. How can I match these informations to the devices?
Could you explain how to enable the notice of
- filling level of the cartridge
- pagecounter
- IP/MAC adress?
Thanks!
Last edited by MarcusO (2012-05-03 17:27:43)
Offline
After have made network inventory (get few informations), you may do network inventory (SNMP inventory) to inventory devices by SNMP and get all informations
Offline
Thanky for your reply, but I don't quite follow. How can I do SNMP inventory? The tasks are are done automatically, aren't they?
Network scanning works good for computers, monitors and software.
Offline
Network scanning don't get monitors and software of computers, local inventory (with agent installed on each computer) do this
Offline
You are right, it was a missunderstanding from my side. :-)
I defined an IP adress range. What are the next steps?
Offline
Can you give me a hint to do the network inventory? Unfortunately the documentation doesn't deal with this subject.
I have defined two tasks (network scan / SNMP inventory), but there are no results. :-/
Offline
Network inventory and SNMP inventory are working now. How do I find the right SNMP model?
Offline
It may find them, if not, your devices is not supported, see this procedure : http://forge.fusioninventory.org/projec … g_snmpwalk
Offline
Is there a possibility to report on Windows?
Offline
Yes install net-snmp for win32
Offline
Ok, I will report next week.
What can I do if devices are not recognized at all? For example FusionInventory doesn't detect our IP phones and switches (OCS does).
Last edited by MarcusO (2012-03-08 18:05:46)
Offline
Make snmpwalk and send me, after I create SNMP models and so is supported
Offline
Reports are done and will be sent when the mailserver is working again.
I didn't express myself well, there are several devices not detected (not even as unknown devices). :-/
Offline
Hallo David,
there are still several devices not detected at all (for example: all switches). Do you have an advice? Thank you!
Offline
Not detected or in unknown devices ?
Offline
Not detected.
Offline
Not detected = problem in configuration of your switches.
use agent version 2.1.14 (not 2.2 to test it)
Offline